In the Design Configurations tab, you can assign the configurations for the ultimate and serviceability limit state design to a surface.
Assignment
The first of the defined design configurations is preset as the "ultimate configuration" and "serviceability configuration". If you have already defined other configurations, you can select the corresponding entry from the list.
You can create a new configuration using the
button or the list entry. The
button allows you to edit the selected configuration. You can use the
button to graphically adopt the configuration from another surface.
Overview of Design Configurations
This section specifies the factors, as well as the minimum and maximum values that apply to the ultimate and serviceability limit state design according to a standard (see also Chapter Standard Parameters).