Once you have made all the entries in the Load Cases and Combinations dialog box, you can start the calculation directly. The selected load case is calculated using the
button; the
button starts the calculation of all load cases and combinations.
You can also start the calculation of the current load case by clicking the
button in the toolbar (see the image
Calculate Load Case
). Click the
button to start the calculation of all load cases and combinations (see the chapter Starting Calculation of the RFEM manual).
If no results of the modal analysis load case are available yet, you can use the
button in the Selection of Shapes tab to determine the mode shapes without leaving the "Load Cases and Combinations" dialog box.