Question:
How can I display the cross-section warping?
Answer:
The warping of a cross-section can be displayed in the "full mode". For this, it is reasonable to increase the display factor for torsional warping in the control panel; see Image 01.
Question:
How can I display the cross-section warping?
Answer:
The warping of a cross-section can be displayed in the "full mode". For this, it is reasonable to increase the display factor for torsional warping in the control panel; see Image 01.
In the ultimate configuration of the steel joint design, you have the option to modify the limit plastic strain for welds.
The "Base Plate" component allows you to design base plate connections with cast-in anchors. In this case, plates, welds, anchorages, and steel-concrete interaction are analyzed.
In the "Edit Section" dialog box, you can display the buckling shapes of the Finite Strip Method (FSM) as a 3D graphic.