Back to FAQ
1446x
005153
Dipl.-Ing. (FH) Paul Kieloch
2021-12-20

Is it possible to design single-layer reinforced surfaces with RFEM 6?

Is it possible to design single-layer reinforced surfaces with RFEM 6?

Answer:

No, this is not possible in the current state of development of RFEM 6.

See also the FAQ for RFEM 5 and RF‑CONCRETE Surfaces by clicking the link below.
The design concept is currently structured similarly and is based on the reinforcement on the top and bottom sides.

FAQ 005153 | Is it possible to design single-layer reinforced surfaces with RFEM 6?
FAQ 005153 | Is it possible to design single-layer reinforced surfaces with RFEM 6?
Author

Mr. Kieloch provides technical support to our customers and is responsible for development in the area of reinforced concrete structures.

;