Great praise again, I really enjoy my structural analyses with RFEM. Your advertising slogan is actually true.
Enjoying Structural Analyses
Do you have any questions?
Length: 00:01:07 min
Length: 00:45:10 min
Length: 00:00:54 min
Knowledge Base
Length: 00:00:51 min
Length: 01:04:03 min
Length: 00:54:02 min
Length: 01:06:40 min
Product Feature
Length: 00:00:36 min
Product Feature
Length: 00:00:35 min
This article will show you how to define longitudinal ribs on a member plate using the “Rib” component in the Steel Joints Add-On.
This article draws a parallel between generating an FE mesh for separate objects using the “Independent FE mesh preferred” option, and generating the mesh without using said option.
In this article, you will learn how to model a simple end plate connection in RFEM 6.
Utilizing the Steel Design Add-on, steel design is possible according to the AISC 360-22 standard. The following article will compare the result output when calculating lateral torsional buckling according to Chapter F vs. an Eigenvalue Analysis.
For the fire resistance design of timber surfaces, you can display a charring diagram depending on the time of fire exposure.
It is also possible to print this charring diagram into the printout report.
In the Concrete Design add-on for RFEM 6, you can perform the fire design of reinforced concrete slabs and walls according to the simplified table method (EN 1992‑1‑2, Section 5.4.2 and Tables 5.8 and 5.9).
In the Concrete Design add-on, you have the option to define an existing vertically oriented punching shear reinforcement. This is then taken into account in the punching shear design.
In RFEM, the oriented strand board (OSB) material is available for the USA and Canada. The material parameters are taken from the "Panel Design Specification manual".
How can I exclude the dead load in NBC load combinations when performing a deflection check?
Can I add dimensions in the Steel Joints add-on?
Why do I only obtain the total reinforcement in the Results navigator under "Required Reinforcement", and no result for the top and bottom reinforcements separately?
How can I design single-angle compression member according to AISC Section E5?
What is the conservatism factor for CLT in Timber Design?
How do the stiffeners on the outer flange edges of a rigid frame joint beam affect the maximum resistant moment as well as the rotational stiffness and the accompanying displacements on a frame structure?
.png?mw=350&hash=87067b88e84e78e23f7a538dec586f8442297bd4)
