Programming with RFEM 6 and Python essentially requires two things: RFEM 6 and Python.
Contents:
0:00:14 Activating Web Services
0:01:01 Python (Command Prompt)
0:01:23 Python (IDLE)
0:01:57 Python (VS Code)
0:02:55 GitHub
Programming with RFEM 6 and Python | 003 Installation
Links
Do you have any questions?
Length: 00:03:13 min
Length: 00:03:15 min
Length: 00:04:23 min
Length: 00:04:08 min
Length: 00:13:34 min
Length: 00:09:53 min
Knowledge Base
Length: 00:01:24 min
Knowledge Base
Length: 00:00:00 min
Length: 01:04:39 min
Webservice is a communication between machines and programs. This communication is provided via the network and can, therefore, be used by any program that can send and receive strings via the HTTP protocol. RFEM 6 and RSTAB 9 provide an interface based on these cross-platform webservices. This tutorial shows the basics using the VBA programming language.
In this article, you will learn how to model and design cable structures in RFEM 6 or RSTAB 9.
This article describes and explains the influence of bending stiffness of cables on their internal forces. Furthermore, the text provides information on how this influence can be reduced.
The ASCE 7-22 Standard [1], Sect. 12.9.1.6 specifies when P-delta effects should be considered when running a modal response spectrum analysis for seismic design. In the NBC 2020 [2], Sent. 4.1.8.3.8.c gives only a short requirement that sway effects due to the interaction of gravity loads with the deformed structure should be considered. Therefore, there may be situations where second-order effects, also known as P-delta, must be considered when carrying out a seismic analysis.
The "Bracing in Cells" function allows you to generate diagonal bracing with just a few clicks. You can find this feature under Tools → Generate Model – Members → Bracing in Cells.
In RFEM and RSTAB, you can visualize the flow field quantities of pressure, velocity, turbulence kinetic energy, and turbulence dissipation rate for the wind simulation.
The clipping planes are aligned with the respective wind direction.
In the ultimate configuration of the steel joint design, you have the option to modify the limit plastic strain for welds.
The "Base Plate" component allows you to design base plate connections with cast-in anchors. In this case, plates, welds, anchorages, and steel-concrete interaction are analyzed.
How can I enable model add-ons when using WebService?
How can I create a new model with add-ons enabled?
How can I create a new model with add-ons enabled?
Is it possible to use SHAPE-THIN 9 files in RFEM 6 and RSTAB 9?
Is it possible to use the general method according to EN 1993‑1‑1, 6.3.4 to design structural components with an asymmetric cross-section in the Steel Design add-on for RFEM 6 or RSTAB 9?
Why does the integration/support of my building in the ground below the ground level not work?
How can the NDS and CSA O86 factors be manually adjusted for consideration in the Timber Design add-on?
Is it possible to design a prestressed concrete slab in RFEM 6?
.jpg?mw=350&hash=91f398b559b26a6ac36fd7ecdf5e395e7b9b856d)
