Structural Engineering | SECTOR, d.o.o. Sedejeva 6 5000 NOVA GORICA Slovenia Phone: 00386 41 671 751 Fax: 00386 5 333 26 15 |
Investor | ISKRATEL, d.o.o. Kranj, Slovenia |
Multi-Story Concrete and Steel Building
The building was designed according to Eurocode 2.
Project Specifications
Do you have any questions?
Our webservice offers users the opportunity to communicate with RFEM 6 and RSTAB 9 using various programming languages. Dlubal's high-level functions (HLFs) allow you to expand and simplify the WebService's functionality. In line with RFEM 6 and RSTAB 9, using our WebService makes the engineer's work easier and faster. Check it out now! This tutorial shows you how to use the C# library by means of a simple example.
The building and construction industry is increasingly digitized. Structural engineers, a smaller group in the construction industry, are not always considered to be engineers who follow the latest trends immediately. There is often good reason for this. Many consider this to be the reason that topics such as utilizing the BIM method are not yet the standard in structural engineering. However, the past few years have shown that a process of rethinking has begun, and new digital trends are being picked up and applied.
DIN EN 1998-1 with the National Annex DIN EN 1998-1/NA specifies how to determine seismic loads. The standard applies to structural engineering in seismic areas.
In Germany, DIN EN 1991-1-4 with the National Annex DIN EN 1991-1-4/NA regulates the wind loads. The standard applies to civil engineering works up to an altitude of 300 m.
The Concrete Design add-on for RFEM allows you to perform the fire design of reinforced concrete walls and slabs according to the simplified table method (EN 1992‑1‑2, Section 5.4.2 and Table 5.8 and 5.9).
When generating shear walls and deep beams, you can assign not only surfaces and cells, but also members.
In the Concrete Design add-on, you have the option to define an existing vertically oriented punching shear reinforcement. This is then taken into account in the punching shear design.
In the ultimate configuration of the steel joint design, you have the option to modify the limit plastic strain for welds.
What are Line Hinges and Line Releases?
I just have to calculate an open hall with low roof loads and, compared to them, relatively high wind loads. In theory, it is necessary to perform the lateral-torsional buckling design of the bottom flange. Unfortunately, the combination 1.0*G + 1.5*W is missing.
Recommended Products for You